Jiangmen high altitude equipment rental introduces several common troubleshooting methods of aerial vehicle
In the daily aerial vehicle operation, it is inevitable to encounter a variety of faults, so how to quickly remove the fault problem, as soon as possible to return to normal aerial work? Next Jiangmen aerial vehicle rental small series to introduce to you.
Fault one: failure of gear control
The causes of the failure are as follows:
1. The fork may be damaged
2. The control lever fails due to the failure of positioning ball spring
Solution: go to the special aerial vehicle maintenance point to repair or replace the control lever
Fault 2: oil leakage of hydraulic system
Cause of failure:
1. The joint is loose
2. The seal is damaged
3. Pipe edge fracture or oil sand hole in welded pipe joint
Solution:
1. Tighten the hydraulic system connector
2. Or replace the hydraulic system at a special maintenance point
3. It can be properly repaired or replaced
Fault 3: throttle control valve is not working
Fault causes and solutions:
1. The steel wire rope in the system is stuck. Try to avoid it as soon as possible
2. If the spring is damaged, replace the spring in time
3. The stroke is changed due to the looseness of rope clip
4. Lack of lubricating oil, properly add good lubricating oil
Source: Jiangmen high altitude equipment rental http://www.jmzhongte.com
-
04-23
Common faults and repair methods of hoisting equipment rental in Guangdong
Guangdong lifting equipment in the operation, it is inevitable to encounter crane failure and affect the use of the situation, then the fault maintenance has become a necessary means of disposal. There are three kinds of common faults of Guangdong hoisting equipment rental crane, and the correspondi
-
04-23
What are the advantages of aerial vehicle in aerial vehicle operation
Specific configuration of aerial work vehicle: Hydraulic 360 ° full rotation, three folding arms, single hydraulic lifting cylinder, with bidirectional balance valve. Electrically operated boom. With 1 ton retractable hook, four hydraulic cylinders, adjustable legs, with two-way hydraulic lock (out
-
04-13
Analysis of the reason why the electric hoist of Guangdong hoisting equipment can not operate
Guangdong lifting equipment electric hoist can not run the reason analysis 1, can first check the equipment power fuse is burned, if one phase, so its electric hoist can not rotate, the starting torque of the crane electric hoist is zero, so the motor of the equipment will not run, it is necessary to replace enough fuse. 2. What's more, the voltage of the power grid is too low, so the dynamic torque of the equipment is proportional to the square of the voltage. The acceleration torque can not ov
-
04-13
Jiangmen high altitude equipment rental tells you the harm of overload operation
The excessive stress caused by overload operation of Jiangmen high-altitude equipment can break the wire rope, damage the transmission parts and burn the motor. Due to the insufficient braking force, the brake can not hold the brake, which will cause serious accidents. Overload operation has great damage to the crane structure, such as the main beam deflection, cracks and desoldering on the upper cover plate and web plate, which brings serious accident risks to the high-altitude equipment operat