Jiangmen high altitude equipment rental -- the cause of noise from aerial work vehicle
What are the reasons for the noise of high-altitude equipment during operation? Next Jiangmen high altitude equipment rental to you a brief introduction, mainly the following points.
1. The connection of oil suction pipe is loose and air is inhaled;
2. The viscosity of oil is too high;
3. The speed of the pump is too high;
4. There is air in the oil tank and oil circuit system;
5. The connection of pump shaft and power take-off box transmission device is not concentric;
6. The quality of the pump is not good, the movement is uneven, the oil trapping phenomenon is not well removed or the plunger is stuck, it will make noise;
7. The pipe edge or components are not well fastened, and the pipe clamp is loose;
8. The oil temperature is too low.
Source: Jiangmen high altitude equipment rental http://www.jmzhongte.com
-
04-23
Common faults and repair methods of hoisting equipment rental in Guangdong
Guangdong lifting equipment in the operation, it is inevitable to encounter crane failure and affect the use of the situation, then the fault maintenance has become a necessary means of disposal. There are three kinds of common faults of Guangdong hoisting equipment rental crane, and the correspondi
-
04-23
What are the advantages of aerial vehicle in aerial vehicle operation
Specific configuration of aerial work vehicle: Hydraulic 360 ° full rotation, three folding arms, single hydraulic lifting cylinder, with bidirectional balance valve. Electrically operated boom. With 1 ton retractable hook, four hydraulic cylinders, adjustable legs, with two-way hydraulic lock (out
-
04-13
Analysis of the reason why the electric hoist of Guangdong hoisting equipment can not operate
Guangdong lifting equipment electric hoist can not run the reason analysis 1, can first check the equipment power fuse is burned, if one phase, so its electric hoist can not rotate, the starting torque of the crane electric hoist is zero, so the motor of the equipment will not run, it is necessary to replace enough fuse. 2. What's more, the voltage of the power grid is too low, so the dynamic torque of the equipment is proportional to the square of the voltage. The acceleration torque can not ov
-
04-13
Jiangmen high altitude equipment rental tells you the harm of overload operation
The excessive stress caused by overload operation of Jiangmen high-altitude equipment can break the wire rope, damage the transmission parts and burn the motor. Due to the insufficient braking force, the brake can not hold the brake, which will cause serious accidents. Overload operation has great damage to the crane structure, such as the main beam deflection, cracks and desoldering on the upper cover plate and web plate, which brings serious accident risks to the high-altitude equipment operat